Undertile Heating
We stock DEVI undertile heating - the World's leading manufacturer for underfloor heating solutions. Whether you are heating a tiled floor laid on concrete or timber, DEVI offers a cost effective method of warming tiled floors. A variety of thermostats are also available.
Please contact us for any advice or to discuss your requirements. Alternatively, you can call into our showroom.
Installing undertile heating has never been easier or cheaper! The simple installation steps below will give you an insight to how simple it can be:
|
|
Step 1
Measure the room and draw a sketch to help you calculate which DEVI package you will need. Then sketch in the position of the Devimat heating cable mat. |
|
|
Step 2
Mark the positioning of the toilet before you remove it. This helps you avoid placing the toilet on top of the mat - and prevents you from piercing it with screws. |
|
|
Step 3
Cut a channel approx.10mm deep & wide in the wall from the thermostat & about 1m out into floor. Glue flex pipe for the sensor into channel, & seal end of the pipe with piece of tape. |
|
|
Step 4
Clean the floor thoroughly, removing all dirt and soap residue, then lay out the self-adhesive cable mat. The floor surface must be primed if you are not laying the mat on existing tiles. |
|
|
Step 5
Clip through the grey netting to turn the mat over - but make sure that you do not cut through the red cable! |
|
|
Step 6
Turn the mat and position it as required. The self-adhesive effect can withstand 10-20 adjustments, so you can move the mat several times until you are satisfied with the result. |
|
|
Step 7
Once you have positioned the cable mat, you can - depending on the new floor surface - encapsulate it using self levelling screed or cover it with a thin layer of tile adhesive. |
|
